GATE 2015 ME Set 1 · Question 32
1 markMultiple choiceManufacturing EngineeringLimits, Fits, Tolerances and Gauge Design
Holes of diameter are assembled interchangeably with the pins of diameter . The minimum clearance in the assembly will be
- A
0.048 mm
- B
0.015 mm
- C
0.005 mm
- D
0.008 mm
GATE 2015 · Mechanical Engineering · Set 1 · IIT Kanpur
Answer
(B)
From the official answer key published by IIT Kanpur.
Worked solution
The dimensions of the hole and pin (shaft) are given as:
- Hole dimensions:
- Pin dimensions:
The minimum clearance occurs when the hole is at its minimum size and the pin is at its maximum size:
Answer: (B) 0.015 mm
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2015 ME Set 1 · Q40In the assembly shown below, the part dimensions are: L1 = 22.0 0.01 mm, L2 = L3 = 10.0 0.005 mm. Assuming…
- GATE 2015 ME Set 2 · Q32Which one of the following statements is TRUE?
- GATE 2014 ME Set 1 · Q63For the given assembly: 25 H7/g8, match Group A with Group B | Group A | Group B | | :--- | :--- | | P. H |…
- GATE 2014 ME Set 4 · Q62A GO-No GO plug gauge is to be designed for measuring a hole of nominal diameter 25 mm with a hole tolerance…
- GATE 2013 ME · Q37Cylindrical pins of 25+0.020 mm diameter are electroplated in a shop. Thickness of the plating is 30 2.0…
- GATE 2012 ME · Q3In an interchangeable assembly, shafts of size 25.000-0.010+0.040 mm mate with holes of size…
Question from the official GATE 2015 ME paper (Set 1), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.