GATE 2016 ME Set 1 · Question 35
Match the following:
| | | | |
|---|---|---|---|
| P. | Feeler gauge | I. | Radius of an object |
| Q. | Fillet gauge | II. | Diameter within limits by comparison |
| R. | Snap gauge | III. | Clearance or gap between components |
| S. | Cylindrical plug gauge | IV. | Inside diameter of straight hole |
- A
P-III, Q-I, R-II, S-IV
- B
P-III, Q-II, R-I, S-IV
- C
P-IV, Q-II, R-I, S-III
- D
P-IV, Q-I, R-II, S-III
GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.25 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
The standard functions of the given limit and inspection gauges are:
- P. Feeler gauge: Consists of a set of thin steel blades of calibrated thicknesses used to measure small clearances or gaps between mating components (Match: III).
- Q. Fillet gauge (or radius gauge): Used to inspect the concave or convex radius of an object or fillet (Match: I).
- R. Snap gauge: A limit gauge used for checking external dimensions such as shafts or outer diameters within tolerance limits (Match: II).
- S. Cylindrical plug gauge: Used to check the inside diameter (hole dimension) of a straight hole (Match: IV).
Thus, the correct matching combination is P-III, Q-I, R-II, S-IV.
Answer: (A) P-III, Q-I, R-II, S-IV
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2015 ME Set 1 · Q32Holes of diameter 25.0+0.020+0.040 mm are assembled interchangeably with the pins of diameter…
- GATE 2015 ME Set 1 · Q40In the assembly shown below, the part dimensions are: L1 = 22.0 0.01 mm, L2 = L3 = 10.0 0.005 mm. Assuming…
- GATE 2015 ME Set 2 · Q32Which one of the following statements is TRUE?
- GATE 2014 ME Set 1 · Q63For the given assembly: 25 H7/g8, match Group A with Group B | Group A | Group B | | :--- | :--- | | P. H |…
- GATE 2014 ME Set 4 · Q62A GO-No GO plug gauge is to be designed for measuring a hole of nominal diameter 25 mm with a hole tolerance…
- GATE 2013 ME · Q37Cylindrical pins of 25+0.020 mm diameter are electroplated in a shop. Thickness of the plating is 30 2.0…
Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.