GATE 2015 ME Set 2 · Question 32
Which one of the following statements is TRUE?
- A
The ‘GO’ gage controls the upper limit of a hole
- B
The ‘NO GO’ gage controls the lower limit of a shaft
- C
The ‘GO’ gage controls the lower limit of a hole
- D
The ‘NO GO’ gage controls the lower limit of a hole
GATE 2015 · Mechanical Engineering · Set 2 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
According to Taylor's principle of gauge design:
- The GO gauge is designed to check the Maximum Material Condition (MMC) of a feature.
- The NO GO gauge is designed to check the Least Material Condition (LMC).
For an internal feature such as a hole:
- Maximum Material Condition (MMC) occurs when the hole contains the maximum amount of material, which corresponds to the lower limit (minimum diameter) of the hole. Thus, the 'GO' plug gauge controls the lower limit of a hole.
- Least Material Condition (LMC) corresponds to the upper limit (maximum diameter) of the hole, which is controlled by the 'NO GO' gauge.
Therefore, statement (C) is TRUE.
Answer: (C) The ‘GO’ gage controls the lower limit of a hole
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2014 ME Set 1 · Q63For the given assembly: 25 H7/g8, match Group A with Group B | Group A | Group B | | :--- | :--- | | P. H |…
- GATE 2014 ME Set 4 · Q62A GO-No GO plug gauge is to be designed for measuring a hole of nominal diameter 25 mm with a hole tolerance…
- GATE 2013 ME · Q37Cylindrical pins of 25+0.020 mm diameter are electroplated in a shop. Thickness of the plating is 30 2.0…
- GATE 2012 ME · Q3In an interchangeable assembly, shafts of size 25.000-0.010+0.040 mm mate with holes of size…
- GATE 2025 ME · Q25When assembled, the hole 30+0.030+0.000 mm and shaft 30+0.020-0.020 mm will result in
- GATE 2022 ME Set 1 · Q20The type of fit between a mating shaft of diameter 25.0-0.010+0.010 mm and a hole of diameter…
Question from the official GATE 2015 ME paper (Set 2), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.