GATE 2015 ME Set 1 · Question 40
In the assembly shown below, the part dimensions are:
,
.
Assuming the normal distribution of part dimensions, the dimension in mm for assembly condition would be:
- A
- B
- C
- D
GATE 2015 · Mechanical Engineering · Set 1 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
From the assembly diagram, the relation for dimension in terms of the components is:
The nominal value of is:
Assuming a normal distribution of part dimensions, the statistical tolerance (root-sum-square method) for the resultant dimension is given by:
Substituting the given individual tolerances , , and :
Hence, the assembly dimension is . Option (D) corresponds to worst-case (arithmetic) tolerance analysis where .
Answer: (B)
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2015 ME Set 2 · Q32Which one of the following statements is TRUE?
- GATE 2014 ME Set 1 · Q63For the given assembly: 25 H7/g8, match Group A with Group B | Group A | Group B | | :--- | :--- | | P. H |…
- GATE 2014 ME Set 4 · Q62A GO-No GO plug gauge is to be designed for measuring a hole of nominal diameter 25 mm with a hole tolerance…
- GATE 2013 ME · Q37Cylindrical pins of 25+0.020 mm diameter are electroplated in a shop. Thickness of the plating is 30 2.0…
- GATE 2012 ME · Q3In an interchangeable assembly, shafts of size 25.000-0.010+0.040 mm mate with holes of size…
- GATE 2025 ME · Q25When assembled, the hole 30+0.030+0.000 mm and shaft 30+0.020-0.020 mm will result in
Question from the official GATE 2015 ME paper (Set 1), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.