GATE 2019 ME Set 2 · Question 61
2 marksNumerical answerManufacturing EngineeringWelding I: Physics, Power Sources and Arc Welding
A gas tungsten arc welding operation is performed using a current of and an arc voltage of at a welding speed of . Assuming that the arc efficiency is , the net heat input per unit length of the weld will be _____ (round off to one decimal place).
GATE 2019 · Mechanical Engineering · Set 2 · IIT Madras · printed as Q.51 in the ME section
Answer
0.7
From the official answer key published by IIT Madras.
Worked solution
The net heat input per unit length of the weld () is given by:
where:
- is the arc efficiency,
- is the arc voltage,
- is the welding current,
- is the welding speed.
Substituting the given values:
Converting to :
Answer: 0.7
Practise Welding I: Physics, Power Sources and Arc Welding
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welding I: Physics, Power Sources and Arc Welding
- GATE 2018 ME Set 1 · Q22The type of weld represented by the shaded region in the figure is
- GATE 2018 ME Set 2 · Q63A welding operation is being performed with voltage = 30 V and current = 100 A. The cross-sectional area of…
- GATE 2017 ME Set 1 · Q23In an arc welding process, welding speed is doubled. Assuming all other process parameters to be constant,…
- GATE 2016 ME Set 2 · Q32The welding process which uses a blanket of fusible granular flux is
- GATE 2016 ME Set 2 · Q60The voltage-length characteristic of a direct current arc in an arc welding process is V = (100 + 40l),…
- GATE 2015 ME Set 1 · Q34In a linear arc welding process, the heat input per unit length is inversely proportional to
Question from the official GATE 2019 ME paper (Set 2), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.