GATE 2019 ME Set 2 · Question 62
The thickness of a sheet is reduced by rolling (without any change in width) using diameter rolls. Neglect elastic deflection of the rolls and assume that the coefficient of friction at the roll-workpiece interface is . The sheet enters the rotating rolls unaided. If the initial sheet thickness is , the minimum possible final thickness that can be produced by this process in a single pass is _______ (round off to two decimal places).
GATE 2019 · Mechanical Engineering · Set 2 · IIT Madras · printed as Q.52 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
For unaided entry (self-feeding) of a sheet in rolling, the maximum possible reduction in thickness per pass (maximum draft, ) depends on the roll radius and the coefficient of friction :
Given:
- Roll diameter
- Coefficient of friction
- Initial thickness
Calculating the maximum draft:
The minimum possible final thickness is:
Answer: 1.25
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2017 ME Set 2 · Q52A strip of 120 mm width and 8 mm thickness is rolled between two 300 mm-diameter rolls to get a strip of 120…
- GATE 2016 ME Set 1 · Q62A 300 mm thick slab is being cold rolled using roll of 600 mm diameter. If the coefficient of friction is…
- GATE 2015 ME Set 1 · Q31Match the following products with preferred manufacturing processes: | Product | Process | | :--- | :--- | |…
- GATE 2015 ME Set 1 · Q47In a slab rolling operation, the maximum thickness reduction (Δ hmax) is given by Δ hmax = μ2 R, where R is…
- GATE 2015 ME Set 3 · Q41In a rolling operation using rolls of diameter 500 mm, if a 25 mm thick plate cannot be reduced to less than…
- GATE 2014 ME Set 2 · Q63A mild steel plate has to be rolled in one pass such that the final plate thickness is 2/3rd of the initial…
Question from the official GATE 2019 ME paper (Set 2), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.