GATE 2016 ME Set 2 · Question 60
The voltage-length characteristic of a direct current arc in an arc welding process is , where is the length of the arc in mm and is arc voltage in volts. During a welding operation, the arc length varies between and and the welding current is in the range 200-250 A. Assuming a linear power source, the short circuit current is ________ A.
GATE 2016 · Mechanical Engineering · Set 2 · IISc Bangalore · printed as Q.50 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
The arc voltage characteristic is given by:
For the given range of arc lengths and :
For a drooping (linear) power source characteristic, current decreases as voltage increases. Therefore, the operating points are and .
The linear power source equation is:
where the slope is:
The open-circuit voltage is:
The short-circuit current occurs when :
Answer: 425
Practise Welding I: Physics, Power Sources and Arc Welding
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welding I: Physics, Power Sources and Arc Welding
- GATE 2015 ME Set 1 · Q34In a linear arc welding process, the heat input per unit length is inversely proportional to
- GATE 2015 ME Set 1 · Q41A DC welding power source has a linear voltage-current (V-I) characteristic with open circuit voltage of 80…
- GATE 2015 ME Set 2 · Q61During a TIG welding process, the arc current and arc voltage were 50 A and 60 V, respectively, when the…
- GATE 2014 ME Set 1 · Q32The major difficulty during welding of aluminium is due to its
- GATE 2014 ME Set 4 · Q30Within the Heat Affected Zone (HAZ) in a fusion welding process, the work material undergoes
- GATE 2012 ME · Q39In a DC arc welding operation, the voltage-arc length characteristic was obtained as Varc = 20 + 5l where…
Question from the official GATE 2016 ME paper (Set 2), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.