GATE 2018 ME Set 2 · Question 63
A welding operation is being performed with voltage and current . The cross-sectional area of the weld bead is . The work-piece and filler are of titanium for which the specific energy of melting is . Assuming a thermal efficiency of the welding process , the welding speed (in mm/s) is ________ (correct to two decimal places).
GATE 2018 · Mechanical Engineering · Set 2 · IIT Guwahati · printed as Q.53 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
The electrical power supplied during the welding process is:
With a thermal efficiency , the effective heat rate available for melting is:
The heat required to melt the metal per unit time is related to the welding speed (in ) by:
where is the specific energy of melting and is the bead cross-sectional area.
Substituting the given values:
Answer: 7.50
Practise Welding I: Physics, Power Sources and Arc Welding
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welding I: Physics, Power Sources and Arc Welding
- GATE 2017 ME Set 1 · Q23In an arc welding process, welding speed is doubled. Assuming all other process parameters to be constant,…
- GATE 2016 ME Set 2 · Q32The welding process which uses a blanket of fusible granular flux is
- GATE 2016 ME Set 2 · Q60The voltage-length characteristic of a direct current arc in an arc welding process is V = (100 + 40l),…
- GATE 2015 ME Set 1 · Q34In a linear arc welding process, the heat input per unit length is inversely proportional to
- GATE 2015 ME Set 1 · Q41A DC welding power source has a linear voltage-current (V-I) characteristic with open circuit voltage of 80…
- GATE 2015 ME Set 2 · Q61During a TIG welding process, the arc current and arc voltage were 50 A and 60 V, respectively, when the…
Question from the official GATE 2018 ME paper (Set 2), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.