GATE 2015 ME Set 1 · Question 34
In a linear arc welding process, the heat input per unit length is inversely proportional to
- A
welding current
- B
welding voltage
- C
welding speed
- D
duty cycle of the power source
GATE 2015 · Mechanical Engineering · Set 1 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The heat input per unit length () in a linear arc welding process is given by:
where:
- is the arc efficiency,
- is the welding voltage,
- is the welding current, and
- is the welding speed (travel speed of the heat source).
From this relation, the heat input per unit length is directly proportional to the welding voltage and welding current, and inversely proportional to the welding speed .
Hence, as the welding speed increases, the energy delivered per unit length of the weld decreases.
Answer: (C) welding speed
Practise Welding I: Physics, Power Sources and Arc Welding
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welding I: Physics, Power Sources and Arc Welding
- GATE 2015 ME Set 1 · Q41A DC welding power source has a linear voltage-current (V-I) characteristic with open circuit voltage of 80…
- GATE 2015 ME Set 2 · Q61During a TIG welding process, the arc current and arc voltage were 50 A and 60 V, respectively, when the…
- GATE 2014 ME Set 1 · Q32The major difficulty during welding of aluminium is due to its
- GATE 2014 ME Set 4 · Q30Within the Heat Affected Zone (HAZ) in a fusion welding process, the work material undergoes
- GATE 2012 ME · Q39In a DC arc welding operation, the voltage-arc length characteristic was obtained as Varc = 20 + 5l where…
- GATE 2025 ME · Q33During a welding operation, thermal power of 2500 W is incident normally on a metallic surface. As shown in…
Question from the official GATE 2015 ME paper (Set 1), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.