GATE 2020 ME Set 2 · Question 54
There are two identical shaping machines and . In machine , the width of the workpiece is increased by and the feed is decreased by , with respect to that of . If all other conditions remain the same then the ratio of total time per pass in and will be _____ *(round off to one decimal place)*.
GATE 2020 · Mechanical Engineering · Set 2 · IIT Delhi · printed as Q.44 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
The machining time per pass in a shaping machine is given by:
where is the width of the workpiece, is the feed per double stroke, and is the number of double strokes per minute.
For machine :
The total time per pass for is:
Therefore, the ratio of total time per pass in to that in is:
Answer: 0.8
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2019 ME Set 1 · Q25The length, width and thickness of a steel sample are 400 mm, 40 mm and 20 mm, respectively. Its thickness…
- GATE 2019 ME Set 1 · Q62In ASA system, the side cutting and end cutting edge angles of a sharp turning tool are 45° and 10°,…
- GATE 2019 ME Set 2 · Q26The cold forming process in which a hardened tool is pressed against a workpiece (when there is relative…
- GATE 2019 ME Set 2 · Q63A through hole is drilled in an aluminum alloy plate of 15 mm thickness with a drill bit of diameter 10 mm,…
- GATE 2018 ME Set 2 · Q25Feed rate in slab milling operation is equal to
- GATE 2018 ME Set 2 · Q27The preferred option for holding an odd-shaped workpiece in a centre lathe is
Question from the official GATE 2020 ME paper (Set 2), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.