GATE 2020 ME Set 2 · Question 53
A cylindrical bar with diameter is being turned with a tool having geometry (Coordinate system, ASA) resulting in a cutting force . If the tool geometry is changed to (Coordinate system, ASA) and all other parameters remain unchanged, the cutting force changes to . Specific cutting energy (in ) is , where is the specific energy coefficient, and is the uncut thickness in . The value of percentage change in cutting force , i.e. , is _____ *(round off to one decimal place)*.
GATE 2020 · Mechanical Engineering · Set 2 · IIT Delhi · printed as Q.43 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
In the ASA tool signature , the sixth term is the side cutting edge angle .
For the first tool, , and for the second tool, .
The uncut chip thickness is given by:
The cross-sectional area of cut is , which remains constant when depth of cut and feed are unchanged.
The cutting force is related to specific cutting energy as:
Thus, the ratio of cutting forces is:
The percentage change in cutting force is:
Answer: -5.6
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2019 ME Set 1 · Q45In orthogonal turning of a cylindrical tube of wall thickness 5 mm, the axial and the tangential cutting…
- GATE 2019 ME Set 2 · Q64In an orthogonal machining with a single point cutting tool of rake angle 10°, the uncut chip thickness and…
- GATE 2018 ME Set 1 · Q59An orthogonal cutting operation is being carried out in which uncut thickness is 0.010 mm, cutting speed is…
- GATE 2018 ME Set 2 · Q58Following data correspond to an orthogonal turning of a 100 mm diameter rod on a lathe. Rake angle: +15°;…
- GATE 2017 ME Set 2 · Q55In an orthogonal machining with a tool of 9° orthogonal rake angle, the uncut chip thickness is 0.2 mm. The…
- GATE 2016 ME Set 1 · Q34In an orthogonal cutting process the tool used has rake angle of zero degree. The measured cutting force and…
Question from the official GATE 2020 ME paper (Set 2), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.