GATE 2021 ME Set 1 · Question 18
The correct sequence of machining operations to be performed to finish a large diameter through hole is
- A
drilling, boring, reaming
- B
boring, drilling, reaming
- C
drilling, reaming, boring
- D
boring, reaming, drilling
GATE 2021 · Mechanical Engineering · Set 1 · IIT Bombay · printed as Q.8 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
To produce and finish a large diameter through hole in a solid workpiece, the required sequence is:
1. Drilling: An initial pilot or through hole is created in the solid material using a twist drill. Standard twist drills cannot efficiently or accurately produce very large holes directly.
2. Boring: A single-point boring tool is used to enlarge the drilled hole to the required large diameter, improve concentricity, and correct the axis alignment.
3. Reaming: A multi-edge reamer is used as the final operation to size the hole to a tight tolerance and provide the desired surface finish, removing only a very small amount of material ( to ).
Therefore, the correct sequence is drilling, boring, reaming.
Answer: (A) drilling, boring, reaming
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2020 ME Set 1 · Q52A slot of 25 mm × 25 mm is to be milled in a workpiece of 300 mm length using a side and face milling cutter…
- GATE 2020 ME Set 2 · Q54There are two identical shaping machines S1 and S2. In machine S2, the width of the workpiece is increased…
- GATE 2019 ME Set 1 · Q25The length, width and thickness of a steel sample are 400 mm, 40 mm and 20 mm, respectively. Its thickness…
- GATE 2019 ME Set 1 · Q62In ASA system, the side cutting and end cutting edge angles of a sharp turning tool are 45° and 10°,…
- GATE 2019 ME Set 2 · Q26The cold forming process in which a hardened tool is pressed against a workpiece (when there is relative…
- GATE 2019 ME Set 2 · Q63A through hole is drilled in an aluminum alloy plate of 15 mm thickness with a drill bit of diameter 10 mm,…
Question from the official GATE 2021 ME paper (Set 1), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.