GATE 2020 ME Set 1 · Question 52
A slot of is to be milled in a workpiece of length using a side and face milling cutter of diameter , width and having 20 teeth.
For a depth of cut , feed per tooth , cutting speed and approach and over travel distance of each, the time required for milling the slot is ________ minutes *(round off to one decimal place)*.
GATE 2020 · Mechanical Engineering · Set 1 · IIT Delhi · printed as Q.42 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
Given:
- Slot dimensions: depth , width
- Workpiece length:
- Cutter diameter: , width: , teeth:
- Depth of cut per pass:
- Feed per tooth:
- Cutting speed:
1. Number of passes:
2. Rotational speed of the cutter:
3. Table feed rate:
4. Length of travel per pass:
Including the compulsory approach and overtravel , and the geometrical approach :
(If only the given approach and overtravel are considered, .)
5. Machining time:
(Using gives .)
Both values fall well within the official range of 7 to 9 minutes.
Answer: 7.4
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2020 ME Set 2 · Q54There are two identical shaping machines S1 and S2. In machine S2, the width of the workpiece is increased…
- GATE 2019 ME Set 1 · Q25The length, width and thickness of a steel sample are 400 mm, 40 mm and 20 mm, respectively. Its thickness…
- GATE 2019 ME Set 1 · Q62In ASA system, the side cutting and end cutting edge angles of a sharp turning tool are 45° and 10°,…
- GATE 2019 ME Set 2 · Q26The cold forming process in which a hardened tool is pressed against a workpiece (when there is relative…
- GATE 2019 ME Set 2 · Q63A through hole is drilled in an aluminum alloy plate of 15 mm thickness with a drill bit of diameter 10 mm,…
- GATE 2018 ME Set 2 · Q25Feed rate in slab milling operation is equal to
Question from the official GATE 2020 ME paper (Set 1), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.