GATE 2021 ME Set 1 · Question 20
Consider the surface roughness profile as shown in the figure.
The center line average roughness (, in ) of the measured length () is
- A
- B
- C
- D
GATE 2021 · Mechanical Engineering · Set 1 · IIT Bombay · printed as Q.10 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
The Center Line Average (CLA) roughness, denoted by , is defined as the arithmetic average of the absolute values of the profile deviations from the mean line over the evaluation length :
From the given roughness profile, over each of the four equal segments of length :
- :
- :
- :
- :
Since over the entire sampling length :
Answer: (B)
Practise Linear, Angular, Form & Surface Metrology
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Linear, Angular, Form & Surface Metrology
- GATE 2021 ME Set 2 · Q52A 76.2 mm gauge block is used under one end of a 254 mm sine bar with roll diameter of 25.4 mm. The height…
- GATE 2020 ME Set 2 · Q22The figure below shows a symbolic representation of the surface texture in a perpendicular lay orientation…
- GATE 2020 ME Set 2 · Q42Two rollers of diameters D1 (in mm) and D2 (in mm) are used to measure the internal taper angle in the…
- GATE 2018 ME Set 1 · Q35The height (in mm) for a 125 mm sine bar to measure a taper of 27° 32' on a flat work piece is ________…
- GATE 2017 ME Set 1 · Q50Assume that the surface roughness profile is triangular as shown schematically in the figure. If the peak to…
- GATE 2016 ME Set 3 · Q62Two optically flat plates of glass are kept at a small angle θ as shown in the figure. Monochromatic light…
Question from the official GATE 2021 ME paper (Set 1), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.