GATE 2021 ME Set 2 · Question 52
A gauge block is used under one end of a sine bar with roll diameter of . The height of gauge blocks required at the other end of the sine bar to measure an angle of is ________ (round off to two decimal places).
GATE 2021 · Mechanical Engineering · Set 2 · IIT Bombay · printed as Q.42 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
For a sine bar of length set at an angle to the horizontal, the vertical height difference between the centers of its two rolls is given by:
Given:
- Length of sine bar,
- Angle to measure,
- Gauge block height under the lower end,
The required height difference between the two ends is:
Therefore, the height of the gauge blocks at the other end, , is:
Answer: 203.20
Practise Linear, Angular, Form & Surface Metrology
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Linear, Angular, Form & Surface Metrology
- GATE 2020 ME Set 2 · Q22The figure below shows a symbolic representation of the surface texture in a perpendicular lay orientation…
- GATE 2020 ME Set 2 · Q42Two rollers of diameters D1 (in mm) and D2 (in mm) are used to measure the internal taper angle in the…
- GATE 2018 ME Set 1 · Q35The height (in mm) for a 125 mm sine bar to measure a taper of 27° 32' on a flat work piece is ________…
- GATE 2017 ME Set 1 · Q50Assume that the surface roughness profile is triangular as shown schematically in the figure. If the peak to…
- GATE 2016 ME Set 3 · Q62Two optically flat plates of glass are kept at a small angle θ as shown in the figure. Monochromatic light…
- GATE 2014 ME Set 1 · Q31Which one of the following instruments is widely used to check and calibrate geometric features of machine…
Question from the official GATE 2021 ME paper (Set 2), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.