GATE 2017 ME Set 1 · Question 50
Assume that the surface roughness profile is triangular as shown schematically in the figure. If the peak to valley height is , the central line average surface roughness (in ) is
- A
5
- B
6.67
- C
10
- D
20
GATE 2017 · Mechanical Engineering · Set 1 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The centerline average roughness is defined as the arithmetic average of the absolute deviations of the roughness profile from the mean line:
For a symmetric triangular profile with peak-to-valley height , the mean line lies midway at height from the valleys.
Relative to the mean line, the profile forms identical triangles above and below the line with maximum deviation .
For any linear triangular variation of height , the average value is:
Substituting the given peak-to-valley height:
Answer: (A) 5
Practise Linear, Angular, Form & Surface Metrology
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Linear, Angular, Form & Surface Metrology
- GATE 2016 ME Set 3 · Q62Two optically flat plates of glass are kept at a small angle θ as shown in the figure. Monochromatic light…
- GATE 2014 ME Set 1 · Q31Which one of the following instruments is widely used to check and calibrate geometric features of machine…
- GATE 2014 ME Set 2 · Q30The flatness of a machine bed can be measured using
- GATE 2014 ME Set 3 · Q63The diameter of a recessed ring was measured by using two spherical balls of diameter d2=60 mm and d1=40 mm…
- GATE 2013 ME · Q12A metric thread of pitch 2 mm and thread angle 60° is inspected for its pitch diameter using 3-wire method.…
- GATE 2026 ME · Q33A two-dimensional surface profile is obtained over a sampling length by using a contact type stylus…
Question from the official GATE 2017 ME paper (Set 1), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.