GATE 2018 ME Set 1 · Question 35
The height (in mm) for a sine bar to measure a taper of on a flat work piece is ________ (correct to three decimal places).
GATE 2018 · Mechanical Engineering · Set 1 · IIT Guwahati · printed as Q.25 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
A sine bar utilizes the trigonometric sine relationship to measure taper angles. The relation between the height of the slip gauge pack , the length of the sine bar , and the taper angle is:
Given:
- Length of the sine bar,
- Taper angle,
Calculating the sine of the angle:
Now, solving for the height :
Answer: 57.783
Practise Linear, Angular, Form & Surface Metrology
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Linear, Angular, Form & Surface Metrology
- GATE 2017 ME Set 1 · Q50Assume that the surface roughness profile is triangular as shown schematically in the figure. If the peak to…
- GATE 2016 ME Set 3 · Q62Two optically flat plates of glass are kept at a small angle θ as shown in the figure. Monochromatic light…
- GATE 2014 ME Set 1 · Q31Which one of the following instruments is widely used to check and calibrate geometric features of machine…
- GATE 2014 ME Set 2 · Q30The flatness of a machine bed can be measured using
- GATE 2014 ME Set 3 · Q63The diameter of a recessed ring was measured by using two spherical balls of diameter d2=60 mm and d1=40 mm…
- GATE 2013 ME · Q12A metric thread of pitch 2 mm and thread angle 60° is inspected for its pitch diameter using 3-wire method.…
Question from the official GATE 2018 ME paper (Set 1), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.