PARIXO GATE · ME Open the app

GATE 2021 ME Set 2 · Question 49

2 marksNumerical answerManufacturing EngineeringAbrasive Processes and Jigs & Fixtures

A surface grinding operation has been performed on a Cast Iron plate having dimensions . The grinding was performed using an alumina wheel having a wheel diameter of and wheel width of . The grinding velocity used is , table speed is , depth of cut per pass is and the number of grinding passes is . The average tangential and average normal force for each pass is found to be and respectively. The value of the specific grinding energy under the aforesaid grinding conditions is ________ (round off to one decimal place).

GATE 2021 · Mechanical Engineering · Set 2 · IIT Bombay · printed as Q.39 in the ME section

Answer
38 to 39

From the official answer key published by IIT Bombay.

Worked solution

The specific grinding energy, , is the power consumed per unit volume of material removed:

Given:

  • Wheel tangential force,
  • Grinding velocity,
  • Width of cut (workpiece width),
  • Depth of cut per pass,
  • Table speed (workpiece velocity),

Calculate the grinding power:

Calculate the material removal rate (MRR):

Thus, the specific grinding energy is:

Answer: 38.4

Practise Abrasive Processes and Jigs & Fixtures

7 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Abrasive Processes and Jigs & Fixtures

Question from the official GATE 2021 ME paper (Set 2), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.