GATE 2021 ME Set 2 · Question 50
In a pure orthogonal turning by a zero rake angle single point carbide cutting tool, the shear force has been computed to be . The cutting velocity, , depth of cut, , feed, and chip velocity, , the shear strength, of the material will be ________ (round off to two decimal places).
GATE 2021 · Mechanical Engineering · Set 2 · IIT Bombay · printed as Q.40 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
In orthogonal turning with a rake angle , the chip thickness ratio is determined from the cutting velocity and chip velocity :
The shear angle is given by:
For depth of cut (width of cut) and feed (uncut chip thickness) , the shear area is:
The shear strength of the material is:
Answer: 392.23
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2020 ME Set 1 · Q55In a turning process using orthogonal tool geometry, a chip length of 100 mm is obtained for an uncut chip…
- GATE 2020 ME Set 2 · Q53A cylindrical bar with 200 mm diameter is being turned with a tool having geometry 0° - 9° - 7° - 8° - 15° -…
- GATE 2019 ME Set 1 · Q45In orthogonal turning of a cylindrical tube of wall thickness 5 mm, the axial and the tangential cutting…
- GATE 2019 ME Set 2 · Q64In an orthogonal machining with a single point cutting tool of rake angle 10°, the uncut chip thickness and…
- GATE 2018 ME Set 1 · Q59An orthogonal cutting operation is being carried out in which uncut thickness is 0.010 mm, cutting speed is…
- GATE 2018 ME Set 2 · Q58Following data correspond to an orthogonal turning of a 100 mm diameter rod on a lathe. Rake angle: +15°;…
Question from the official GATE 2021 ME paper (Set 2), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.