GATE 2023 ME · Question 15
A cuboidal part has to be accurately positioned first, arresting six degrees of freedom and then clamped in a fixture, to be used for machining. Locating pins in the form of cylinders with hemi-spherical tips are to be placed on the fixture for positioning. Four different configurations of locating pins are proposed as shown. Which one of the options given is correct?
- A
Configuration P1 arrests 6 degrees of freedom, while Configurations P2 and P4 are over-constrained and Configuration P3 is under-constrained.
- B
Configuration P2 arrests 6 degrees of freedom, while Configurations P1 and P3 are over-constrained and Configuration P4 is under-constrained.
- C
Configuration P3 arrests 6 degrees of freedom, while Configurations P2 and P4 are over-constrained and Configuration P1 is under-constrained.
- D
Configuration P4 arrests 6 degrees of freedom, while Configurations P1 and P3 are over-constrained and Configuration P2 is under-constrained.
GATE 2023 · Mechanical Engineering · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
According to the 3-2-1 principle of fixture design, a 3D solid body has 12 degrees of freedom (6 translational and 6 rotational along/about three mutually perpendicular axes). To fully locate and arrest all 6 independent degrees of freedom without redundancy:
1. Primary datum plane: 3 non-collinear locating pins arrest 3 degrees of freedom (1 translation normal to the plane and 2 rotations about axes in the plane).
2. Secondary datum plane: 2 locating pins on a perpendicular side face arrest 2 degrees of freedom (1 translation and 1 rotation).
3. Tertiary datum plane: 1 locating pin on a third mutually perpendicular face arrests the remaining 1 translation degree of freedom.
Evaluating the configurations:
- P1: Uses 3 pins on the bottom face, 2 pins on the side face, and 1 pin on the adjacent face ( pins), correctly arresting all 6 DOFs.
- P2: Uses 4 pins on the bottom, 2 on the side, 1 on the adjacent ( pins) over-constrained.
- P3: Uses 3 pins on the bottom, 1 on the side, 1 on the adjacent ( pins) under-constrained.
- P4: Uses 4 pins on the bottom, 2 on the side, 2 on the adjacent ( pins) over-constrained.
Answer: (A)
Practise Abrasive Processes and Jigs & Fixtures
7 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Abrasive Processes and Jigs & Fixtures
- GATE 2021 ME Set 1 · Q49In a grinding operation of a metal, specific energy consumption is 15 J/mm3. If a grinding wheel with a…
- GATE 2021 ME Set 2 · Q49A surface grinding operation has been performed on a Cast Iron plate having dimensions 300 mm (length) × 10…
- GATE 2020 ME Set 1 · Q22The base of a brass bracket needs rough grinding. For this purpose, the most suitable grinding wheel grade…
- GATE 2018 ME Set 1 · Q24A grinding ratio of 200 implies that the
- GATE 2026 ME · Q32A work piece is to be firmly held in a fixture. It is to be machined by using a plain slab milling cutter as…
- GATE 2024 ME · Q30The grinding wheel used to provide the best surface finish is
Question from the official GATE 2023 ME paper, IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.