PARIXO GATE · ME Open the app

GATE 2026 ME · Question 32

1 markMultiple choiceManufacturing EngineeringAbrasive Processes and Jigs & Fixtures

A work piece is to be firmly held in a fixture. It is to be machined by using a plain slab milling cutter as shown in the figure below.

Which one of the following options is the most suitable value of height H of the fixture in mm?

Figure 1 for GATE 2026 ME question 32
  1. A

    200

  2. B

    70

  3. C

    150

  4. D

    210

GATE 2026 · Mechanical Engineering · IIT Guwahati

Answer
(A)

From the official answer key published by IIT Guwahati.

Worked solution

In fixture design for machining operations like plain slab milling:
1. To minimize bending deflection, vibration, and chatter during cutting, the workpiece must be supported as close to the machined surface as possible.
2. The fixture must not interfere with or foul the cutter tool path. The machined height from the base is given as .

Therefore, the height of the fixture must be slightly less than the cutting surface height () to avoid cutter collision, while being maximized to provide maximum rigidity.

  • exceeds , leading to cutter collision.
  • and leave a long unsupported overhang, leading to poor rigidity and chatter.
  • offers maximal support with safe clearance () for the cutter.

Answer: (A) 200

Practise Abrasive Processes and Jigs & Fixtures

7 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Abrasive Processes and Jigs & Fixtures

Question from the official GATE 2026 ME paper, IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.