GATE 2022 ME Set 1 · Question 20
The type of fit between a mating shaft of diameter and a hole of diameter is ________.
- A
Clearance
- B
Transition
- C
Interference
- D
Linear
GATE 2022 · Mechanical Engineering · Set 1 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
Determine the limits of size for the mating hole and shaft:
For the hole of diameter :
- Upper limit of hole () =
- Lower limit of hole () =
For the shaft of diameter :
- Upper limit of shaft () =
- Lower limit of shaft () =
Now evaluate the clearances:
- Maximum clearance = (clearance occurs)
- Minimum clearance = (interference occurs)
Since the tolerance zones overlap—giving either a clearance or an interference depending on the actual sizes of the mating parts—the fit is a transition fit.
Answer: (B) Transition
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2022 ME Set 2 · Q20A shaft of diameter 25-0.07-0.04 mm is assembled in a hole of diameter 25-0.00+0.02 mm. Match the allowance…
- GATE 2021 ME Set 2 · Q19The allowance provided in between a hole and a shaft is calculated from the difference between
- GATE 2020 ME Set 1 · Q53The following data applies to basic shaft system: tolerance for hole = 0.002 mm, tolerance for shaft = 0.001…
- GATE 2019 ME Set 1 · Q46A circular shaft having diameter 65.00-0.05+0.01 mm is manufactured by turning process. A 50 μm thick…
- GATE 2019 ME Set 2 · Q27The most common limit gage used for inspecting the hole diameter is
- GATE 2017 ME Set 2 · Q24The standard deviation of linear dimensions P and Q are 3 μm and 4 μm, respectively. When assembled, the…
Question from the official GATE 2022 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.