GATE 2021 ME Set 2 · Question 19
The allowance provided in between a hole and a shaft is calculated from the difference between
- A
lower limit of the shaft and the upper limit of the hole
- B
upper limit of the shaft and the upper limit of the hole
- C
upper limit of the shaft and the lower limit of the hole
- D
lower limit of the shaft and the lower limit of the hole
GATE 2021 · Mechanical Engineering · Set 2 · IIT Bombay · printed as Q.9 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
Allowance is the intentional, prescribed difference between the dimensions of mating parts at their maximum material condition (MMC) to achieve the desired type of fit (clearance or interference).
For a hole and shaft assembly:
- The maximum material condition for a hole occurs at its minimum size, which is the lower limit of the hole.
- The maximum material condition for a shaft occurs at its maximum size, which is the upper limit of the shaft.
Therefore, the allowance is calculated from the difference between the lower limit of the hole and the upper limit of the shaft:
Hence, it is determined from the difference between the upper limit of the shaft and the lower limit of the hole.
Answer: (C) upper limit of the shaft and the lower limit of the hole
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2020 ME Set 1 · Q53The following data applies to basic shaft system: tolerance for hole = 0.002 mm, tolerance for shaft = 0.001…
- GATE 2019 ME Set 1 · Q46A circular shaft having diameter 65.00-0.05+0.01 mm is manufactured by turning process. A 50 μm thick…
- GATE 2019 ME Set 2 · Q27The most common limit gage used for inspecting the hole diameter is
- GATE 2017 ME Set 2 · Q24The standard deviation of linear dimensions P and Q are 3 μm and 4 μm, respectively. When assembled, the…
- GATE 2017 ME Set 2 · Q53A cylindrical pin of 25+0.020+0.010 mm diameter is electroplated. Plating thickness is 2.0 0.005 mm.…
- GATE 2016 ME Set 1 · Q35Match the following: | | | | | |---|---|---|---| | P. | Feeler gauge | I. | Radius of an object | | Q. |…
Question from the official GATE 2021 ME paper (Set 2), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.