GATE 2019 ME Set 1 · Question 46
A circular shaft having diameter is manufactured by turning process. A thick coating of TiN is deposited on the shaft. Allowed variation in TiN film thickness is . The minimum hole diameter (in mm) to just provide clearance fit is
- A
65.01
- B
65.12
- C
64.95
- D
65.10
GATE 2019 · Mechanical Engineering · Set 1 · IIT Madras · printed as Q.36 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
The maximum diameter of the shaft before coating corresponds to its upper limit:
The TiN coating thickness has a maximum value of:
Since the coating is deposited uniformly around the circular cross-section, it adds to the radius on all sides, increasing the diameter by :
To guarantee a clearance fit under the worst-case condition (clearance ):
Answer: (B) 65.12
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2019 ME Set 2 · Q27The most common limit gage used for inspecting the hole diameter is
- GATE 2017 ME Set 2 · Q24The standard deviation of linear dimensions P and Q are 3 μm and 4 μm, respectively. When assembled, the…
- GATE 2017 ME Set 2 · Q53A cylindrical pin of 25+0.020+0.010 mm diameter is electroplated. Plating thickness is 2.0 0.005 mm.…
- GATE 2016 ME Set 1 · Q35Match the following: | | | | | |---|---|---|---| | P. | Feeler gauge | I. | Radius of an object | | Q. |…
- GATE 2015 ME Set 1 · Q32Holes of diameter 25.0+0.020+0.040 mm are assembled interchangeably with the pins of diameter…
- GATE 2015 ME Set 1 · Q40In the assembly shown below, the part dimensions are: L1 = 22.0 0.01 mm, L2 = L3 = 10.0 0.005 mm. Assuming…
Question from the official GATE 2019 ME paper (Set 1), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.