GATE 2022 ME Set 2 · Question 20
A shaft of diameter is assembled in a hole of diameter . Match the allowance and limit parameter in Column I with its corresponding quantitative value in Column II for this shaft-hole assembly.
| Allowance and limit parameter (Column I) | Quantitative value (Column II) |
| :--- | :--- |
| P Allowance | 1 0.09 mm |
| Q Maximum clearance | 2 24.96 mm |
| R Maximum material limit for hole | 3 0.04 mm |
| | 4 25.0 mm |
- A
P-3, Q-1, R-4
- B
P-1, Q-3, R-2
- C
P-1, Q-3, R-4
- D
P-3, Q-1, R-2
GATE 2022 · Mechanical Engineering · Set 2 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
Given the dimensions for the shaft and hole:
- Shaft:
- Upper limit:
- Lower limit:
- Hole:
- Upper limit:
- Lower limit:
Now, evaluating each parameter:
- P (Allowance): The intentional difference between the maximum material limits of mating parts (here, the minimum clearance):
- Q (Maximum clearance): The difference between the maximum hole size and minimum shaft size:
- R (Maximum material limit for hole): Corresponds to the minimum hole diameter:
Therefore, the correct matching is P-3, Q-1, R-4.
Answer: (A) P-3, Q-1, R-4
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2021 ME Set 2 · Q19The allowance provided in between a hole and a shaft is calculated from the difference between
- GATE 2020 ME Set 1 · Q53The following data applies to basic shaft system: tolerance for hole = 0.002 mm, tolerance for shaft = 0.001…
- GATE 2019 ME Set 1 · Q46A circular shaft having diameter 65.00-0.05+0.01 mm is manufactured by turning process. A 50 μm thick…
- GATE 2019 ME Set 2 · Q27The most common limit gage used for inspecting the hole diameter is
- GATE 2017 ME Set 2 · Q24The standard deviation of linear dimensions P and Q are 3 μm and 4 μm, respectively. When assembled, the…
- GATE 2017 ME Set 2 · Q53A cylindrical pin of 25+0.020+0.010 mm diameter is electroplated. Plating thickness is 2.0 0.005 mm.…
Question from the official GATE 2022 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.