GATE 2020 ME Set 1 · Question 53
The following data applies to basic shaft system:
tolerance for hole = ,
tolerance for shaft = ,
allowance = ,
basic size = .
The maximum hole size is ________ *(round off to 3 decimal places)*.
GATE 2020 · Mechanical Engineering · Set 1 · IIT Delhi · printed as Q.43 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
In a basic shaft system, the upper deviation of the shaft is zero, meaning the maximum shaft size equals the basic size:
The allowance is the minimum clearance between the hole and the shaft:
Substituting the given values:
The maximum hole size is obtained by adding the hole tolerance to the minimum hole size:
Answer: 50.005
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2019 ME Set 1 · Q46A circular shaft having diameter 65.00-0.05+0.01 mm is manufactured by turning process. A 50 μm thick…
- GATE 2019 ME Set 2 · Q27The most common limit gage used for inspecting the hole diameter is
- GATE 2017 ME Set 2 · Q24The standard deviation of linear dimensions P and Q are 3 μm and 4 μm, respectively. When assembled, the…
- GATE 2017 ME Set 2 · Q53A cylindrical pin of 25+0.020+0.010 mm diameter is electroplated. Plating thickness is 2.0 0.005 mm.…
- GATE 2016 ME Set 1 · Q35Match the following: | | | | | |---|---|---|---| | P. | Feeler gauge | I. | Radius of an object | | Q. |…
- GATE 2015 ME Set 1 · Q32Holes of diameter 25.0+0.020+0.040 mm are assembled interchangeably with the pins of diameter…
Question from the official GATE 2020 ME paper (Set 1), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.