GATE 2022 ME Set 1 · Question 59
The product structure diagram shows the number of different components required at each level to produce one unit of the final product P. If there are 50 units of on-hand inventory of component A, the number of additional units of component A needed to produce 10 units of product P is ___________ *(in integer)*.
GATE 2022 · Mechanical Engineering · Set 1 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
From the product structure diagram, the total number of units of component A required to make one unit of final product P is the sum of requirements across all paths:
1. Direct requirement at Level 1: units of A per unit of P.
2. Indirect requirement via B and D:
- 1 unit of P requires units of B.
- 1 unit of B requires units of D.
- 1 unit of D requires units of A.
Total gross requirement of A per unit of P is:
For producing units of product P:
Given on-hand inventory of component A is , the additional units needed are:
Answer: 110
Practise Aggregate Planning, MRP and Lean Manufacturing
5 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Aggregate Planning, MRP and Lean Manufacturing
- GATE 2021 ME Set 2 · Q39A factory produces m (i = 1, 2, , m) products, each of which requires processing on n (j = 1, 2, , n)…
- GATE 2020 ME Set 1 · Q43For an assembly line, the production rate was 4 pieces per hour and the average processing time was 60…
- GATE 2020 ME Set 2 · Q23In Materials Requirement Planning, if the inventory holding cost is very high and the setup cost is zero,…
- GATE 2012 ME · Q13Which one of the following is NOT a decision taken during the aggregate production planning stage?
Question from the official GATE 2022 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.