GATE 2022 ME Set 2 · Question 56
The best size wire is fitted in a groove of a metric screw such that the wire touches the flanks of the thread on the pitch line as shown in the figure. The pitch () and included angle of the thread are 4 mm and , respectively. The diameter of the best size wire is _________ *(round off to 2 decimal places)*.
GATE 2022 · Mechanical Engineering · Set 2 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The best size wire touches the flanks of the thread along the pitch line where the thread thickness equals half the pitch, i.e., .
For a symmetrical thread with included angle (where the half-angle is ):
From the geometry of the triangle formed by the wire center, the contact point on the pitch line, and the thread axis:
Given the thread pitch and included thread angle (so ):
Answer: 2.31
Practise Linear, Angular, Form & Surface Metrology
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Linear, Angular, Form & Surface Metrology
- GATE 2021 ME Set 1 · Q20Consider the surface roughness profile as shown in the figure. The center line average roughness (Ra, in μm)…
- GATE 2021 ME Set 2 · Q52A 76.2 mm gauge block is used under one end of a 254 mm sine bar with roll diameter of 25.4 mm. The height…
- GATE 2020 ME Set 2 · Q22The figure below shows a symbolic representation of the surface texture in a perpendicular lay orientation…
- GATE 2020 ME Set 2 · Q42Two rollers of diameters D1 (in mm) and D2 (in mm) are used to measure the internal taper angle in the…
- GATE 2018 ME Set 1 · Q35The height (in mm) for a 125 mm sine bar to measure a taper of 27° 32' on a flat work piece is ________…
- GATE 2017 ME Set 1 · Q50Assume that the surface roughness profile is triangular as shown schematically in the figure. If the peak to…
Question from the official GATE 2022 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.