GATE 2024 ME · Question 63
In an arc welding process, the voltage and current are and , respectively. The cross-sectional area of the joint is and the welding speed is . The heat required to melt the material is . The percentage of heat lost to the surrounding during the welding process is _______ *(rounded off to 2 decimal places)*.
GATE 2024 · Mechanical Engineering · IISc Bangalore
Answer
From the official answer key published by IISc Bangalore.
Worked solution
The electrical power input to the arc is:
If the heat required to melt the material is taken directly as :
However, the melting energy of materials is typically specified in rather than . Because the unit of heat required to melt was incorrectly specified as instead of energy per unit volume (which would yield a melting power of ), this question was declared ambiguous and dropped.
Answer: Marks to all (the question was dropped)
Practise Welding I: Physics, Power Sources and Arc Welding
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welding I: Physics, Power Sources and Arc Welding
- GATE 2022 ME Set 1 · Q57Two mild steel plates of similar thickness, in butt-joint configuration, are welded by gas tungsten arc…
- GATE 2022 ME Set 2 · Q57In a direct current arc welding process, the power source has an open circuit voltage of 100 V and short…
- GATE 2020 ME Set 2 · Q20Two plates, each of 6 mm thickness, are to be butt-welded. Consider the following processes and select the…
- GATE 2019 ME Set 2 · Q61A gas tungsten arc welding operation is performed using a current of 250 A and an arc voltage of 20 V at a…
- GATE 2018 ME Set 1 · Q22The type of weld represented by the shaded region in the figure is
- GATE 2018 ME Set 2 · Q63A welding operation is being performed with voltage = 30 V and current = 100 A. The cross-sectional area of…
Question from the official GATE 2024 ME paper, IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.