GATE 2025 ME · Question 33
During a welding operation, thermal power of is incident normally on a metallic surface. As shown in the figure below (figure is NOT to scale), the heated area is circular. Out of the incident power, of the power is absorbed within a circle of radius while is absorbed within an inner concentric circle of radius . The power density in the shaded area is \underline{\hspace{1cm}} (rounded off to 2 decimal places).
GATE 2025 · Mechanical Engineering · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The total power incident on the metallic surface is .
The power absorbed within the circle of radius is:
The power absorbed within the inner circle of radius is:
The power absorbed in the shaded annular region between and is:
The area of this shaded annular region is:
Therefore, the average power density in the shaded area is:
Answer: 9.95
Practise Welding I: Physics, Power Sources and Arc Welding
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welding I: Physics, Power Sources and Arc Welding
- GATE 2024 ME · Q32The most suitable electrode material used for joining low alloy steels using Gas Metal Arc Welding (GMAW)…
- GATE 2024 ME · Q63In an arc welding process, the voltage and current are 30 V and 200 A, respectively. The cross-sectional…
- GATE 2022 ME Set 1 · Q57Two mild steel plates of similar thickness, in butt-joint configuration, are welded by gas tungsten arc…
- GATE 2022 ME Set 2 · Q57In a direct current arc welding process, the power source has an open circuit voltage of 100 V and short…
- GATE 2020 ME Set 2 · Q20Two plates, each of 6 mm thickness, are to be butt-welded. Consider the following processes and select the…
- GATE 2019 ME Set 2 · Q61A gas tungsten arc welding operation is performed using a current of 250 A and an arc voltage of 20 V at a…
Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.