PARIXO GATE · ME Open the app

GATE 2025 ME · Question 34

1 markNumerical answerManufacturing EngineeringCasting: Patterns, Moulds, Gating and Solidification

A liquid metal is poured in a mold cavity of size . The cooling is uniform in all directions with NO additional compensation for shrinkage. Considering the volumetric shrinkage during solidification and solid contraction as and , respectively, the length of the cube edge after cooling down to the room temperature is \underline{\hspace{1cm}} (rounded off to 1 decimal place).

GATE 2025 · Mechanical Engineering · IIT Roorkee

Answer
189.8 to 190

From the official answer key published by IIT Roorkee.

Worked solution

Let the initial volume of the liquid metal in the mold cavity be:

Given that cooling is uniform in all directions with no compensation for shrinkage:
1. The volumetric shrinkage during solidification is , so the volume of the solid at the freezing temperature is:

2. The solid contraction is , so the final volume at room temperature is:

Since the shrinkage is uniform in all directions, the final cube remains a cube of edge length :

Answer: 189.9

Practise Casting: Patterns, Moulds, Gating and Solidification

34 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Casting: Patterns, Moulds, Gating and Solidification

Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.