GATE 2021 ME Set 1 · Question 48
An orthogonal cutting operation is performed using a single point cutting tool with a rake angle of on a lathe. During turning, the cutting force and the friction force are and , respectively. If the chip thickness and the uncut chip thickness during turning are and , respectively, then the shear force is ______ *(round off to two decimal places)*.
GATE 2021 · Mechanical Engineering · Set 1 · IIT Bombay · printed as Q.38 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
The chip thickness ratio is:
The shear angle is obtained from:
From Merchant's force relations, the friction force is related to cutting force and thrust force by:
The shear force is:
Answer: 685.60
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2021 ME Set 2 · Q50In a pure orthogonal turning by a zero rake angle single point carbide cutting tool, the shear force has…
- GATE 2020 ME Set 1 · Q55In a turning process using orthogonal tool geometry, a chip length of 100 mm is obtained for an uncut chip…
- GATE 2020 ME Set 2 · Q53A cylindrical bar with 200 mm diameter is being turned with a tool having geometry 0° - 9° - 7° - 8° - 15° -…
- GATE 2019 ME Set 1 · Q45In orthogonal turning of a cylindrical tube of wall thickness 5 mm, the axial and the tangential cutting…
- GATE 2019 ME Set 2 · Q64In an orthogonal machining with a single point cutting tool of rake angle 10°, the uncut chip thickness and…
- GATE 2018 ME Set 1 · Q59An orthogonal cutting operation is being carried out in which uncut thickness is 0.010 mm, cutting speed is…
Question from the official GATE 2021 ME paper (Set 1), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.