GATE 2012 ME · Question 28
In a single pass drilling operation, a through hole of diameter is to be drilled in a steel plate of thickness. Drill spindle speed is , feed is and drill point angle is . Assuming clearance at approach and exit, the total drill time (in *seconds*) is
- A
35.1
- B
32.4
- C
31.2
- D
30.1
GATE 2012 · Mechanical Engineering · IIT Delhi
Answer
No official key survives for this paper; this is PARIXO AI's own answer, not official.
Worked solution
The cone height (point height) of the drill with point angle (half angle ) and diameter is:
For a through hole, the total tool travel distance includes the plate thickness , the cone height , approach clearance , and exit clearance :
The drilling feed rate is:
The total drilling time in minutes is:
Converting to seconds:
Answer: (A)
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2024 ME · Q64A flat surface of a C60 steel having dimensions of 100 mm (length) × 200 mm (width) is produced by a HSS…
- GATE 2022 ME Set 2 · Q54A straight-teeth horizontal slab milling cutter is shown in the figure. It has 4 teeth and diameter (D) of…
- GATE 2021 ME Set 1 · Q17In a machining operation, if a cutting tool traces the workpiece such that the directrix is perpendicular to…
- GATE 2021 ME Set 1 · Q18The correct sequence of machining operations to be performed to finish a large diameter through hole is
- GATE 2020 ME Set 1 · Q52A slot of 25 mm × 25 mm is to be milled in a workpiece of 300 mm length using a side and face milling cutter…
- GATE 2020 ME Set 2 · Q54There are two identical shaping machines S1 and S2. In machine S2, the width of the workpiece is increased…
Question from the official GATE 2012 ME paper, IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.