GATE 2012 ME · Question 39
In a DC arc welding operation, the voltage-arc length characteristic was obtained as where the arc length was varied between and . Here denotes the arc voltage in Volts. The arc current was varied from to . Assuming linear power source characteristic, the open circuit voltage and the short circuit current for the welding operation are
- A
- B
- C
- D
GATE 2012 · Mechanical Engineering · IIT Delhi
Answer
No official key survives for this paper; this is PARIXO AI's own answer, not official.
Worked solution
Given the arc characteristic :
- For arc length :
- For arc length :
For a drooping (linear) power source characteristic, current decreases as arc voltage increases:
- At ,
- At ,
The linear relationship between voltage and current is:
- Open circuit voltage ():
- Short circuit current ():
Answer: (C)
Practise Welding I: Physics, Power Sources and Arc Welding
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welding I: Physics, Power Sources and Arc Welding
- GATE 2025 ME · Q33During a welding operation, thermal power of 2500 W is incident normally on a metallic surface. As shown in…
- GATE 2024 ME · Q32The most suitable electrode material used for joining low alloy steels using Gas Metal Arc Welding (GMAW)…
- GATE 2024 ME · Q63In an arc welding process, the voltage and current are 30 V and 200 A, respectively. The cross-sectional…
- GATE 2022 ME Set 1 · Q57Two mild steel plates of similar thickness, in butt-joint configuration, are welded by gas tungsten arc…
- GATE 2022 ME Set 2 · Q57In a direct current arc welding process, the power source has an open circuit voltage of 100 V and short…
- GATE 2020 ME Set 2 · Q20Two plates, each of 6 mm thickness, are to be butt-welded. Consider the following processes and select the…
Question from the official GATE 2012 ME paper, IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.