GATE 2012 ME · Question 38
2 marksMultiple choiceManufacturing EngineeringBulk Deformation I: Forging and Rolling
In a single pass rolling process using diameter steel rollers, a strip of width and thickness undergoes reduction of thickness. The angle of bite in radians is
- A
0.006
- B
0.031
- C
0.062
- D
0.600
GATE 2012 · Mechanical Engineering · IIT Delhi
Answer
(C)
No official key survives for this paper; this is PARIXO AI's own answer, not official.
Worked solution
The draft (reduction in thickness) in the rolling pass is:
The roll radius is:
The angle of bite is related to the draft and roll radius by:
For small angles, this can be approximated as:
Answer: (C)
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2025 ME · Q41A plate of 30 mm thickness is fed through a rolling mill with two powered rolls. Each roll has a diameter of…
- GATE 2022 ME Set 1 · Q56A 4 mm thick aluminum sheet of width w = 100 mm is rolled in a two-roll mill of roll diameter 200 mm each.…
- GATE 2021 ME Set 1 · Q50A 200 mm wide plate having a thickness of 20 mm is fed through a rolling mill with two rolls. The radius of…
- GATE 2021 ME Set 2 · Q51The thickness, width and length of a metal slab are 50 mm, 250 mm and 3600 mm, respectively. A rolling…
- GATE 2020 ME Set 1 · Q42A strip of thickness 40 mm is to be rolled to a thickness of 20 mm using a two-high mill having rolls of…
- GATE 2020 ME Set 1 · Q56The thickness of a steel plate with material strength coefficient of 210 MPa, has to be reduced from 20 mm…
Question from the official GATE 2012 ME paper, IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.