GATE 2012 ME · Question 3
1 markMultiple choiceManufacturing EngineeringLimits, Fits, Tolerances and Gauge Design
In an interchangeable assembly, shafts of size mate with holes of size . The maximum interference (in *microns*) in the assembly is
- A
40
- B
30
- C
20
- D
10
GATE 2012 · Mechanical Engineering · IIT Delhi
Answer
(C)
No official key survives for this paper; this is PARIXO AI's own answer, not official.
Worked solution
The dimensions of the mating parts are given as:
- Shaft size:
- Hole size:
Maximum interference occurs when the largest shaft is assembled with the smallest hole:
Converting to microns ():
Answer: (C)
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2025 ME · Q25When assembled, the hole 30+0.030+0.000 mm and shaft 30+0.020-0.020 mm will result in
- GATE 2022 ME Set 1 · Q20The type of fit between a mating shaft of diameter 25.0-0.010+0.010 mm and a hole of diameter…
- GATE 2022 ME Set 2 · Q20A shaft of diameter 25-0.07-0.04 mm is assembled in a hole of diameter 25-0.00+0.02 mm. Match the allowance…
- GATE 2021 ME Set 2 · Q19The allowance provided in between a hole and a shaft is calculated from the difference between
- GATE 2020 ME Set 1 · Q53The following data applies to basic shaft system: tolerance for hole = 0.002 mm, tolerance for shaft = 0.001…
- GATE 2019 ME Set 1 · Q46A circular shaft having diameter 65.00-0.05+0.01 mm is manufactured by turning process. A 50 μm thick…
Question from the official GATE 2012 ME paper, IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.