GATE 2013 ME · Question 37
Cylindrical pins of diameter are electroplated in a shop. Thickness of the plating is . Neglecting gage tolerances, the size of the GO gage in to inspect the plated components is
- A
- B
- C
- D
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
From the official answer key published by IIT Bombay.
Worked solution
A GO gage for an external cylindrical feature (shaft/pin) is designed to check the Maximum Material Condition (MMC), which corresponds to the maximum allowable diameter of the component.
From the given data:
- Maximum unplated pin diameter:
- Maximum plating thickness:
Since electroplating occurs uniformly over the entire circumference, it adds to both sides of the diameter:
Neglecting gage tolerances, the GO gage size must equal this maximum limit of size, which is .
Answer: (D)
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2012 ME · Q3In an interchangeable assembly, shafts of size 25.000-0.010+0.040 mm mate with holes of size…
- GATE 2025 ME · Q25When assembled, the hole 30+0.030+0.000 mm and shaft 30+0.020-0.020 mm will result in
- GATE 2022 ME Set 1 · Q20The type of fit between a mating shaft of diameter 25.0-0.010+0.010 mm and a hole of diameter…
- GATE 2022 ME Set 2 · Q20A shaft of diameter 25-0.07-0.04 mm is assembled in a hole of diameter 25-0.00+0.02 mm. Match the allowance…
- GATE 2021 ME Set 2 · Q19The allowance provided in between a hole and a shaft is calculated from the difference between
- GATE 2020 ME Set 1 · Q53The following data applies to basic shaft system: tolerance for hole = 0.002 mm, tolerance for shaft = 0.001…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.