GATE 2025 ME · Question 25
When assembled, the hole and shaft will result in
- A
loose fit
- B
interference fit
- C
transition fit
- D
clearance fit
GATE 2025 · Mechanical Engineering · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The dimensions and limits for the hole and shaft are given by:
- Hole limits:
- Shaft limits:
Now calculate the maximum and minimum clearances:
A negative clearance represents an interference of . Because the fit provides either a clearance or an interference depending on the actual sizes of the mating parts, the assembly results in a transition fit.
Answer: (C) transition fit
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2022 ME Set 1 · Q20The type of fit between a mating shaft of diameter 25.0-0.010+0.010 mm and a hole of diameter…
- GATE 2022 ME Set 2 · Q20A shaft of diameter 25-0.07-0.04 mm is assembled in a hole of diameter 25-0.00+0.02 mm. Match the allowance…
- GATE 2021 ME Set 2 · Q19The allowance provided in between a hole and a shaft is calculated from the difference between
- GATE 2020 ME Set 1 · Q53The following data applies to basic shaft system: tolerance for hole = 0.002 mm, tolerance for shaft = 0.001…
- GATE 2019 ME Set 1 · Q46A circular shaft having diameter 65.00-0.05+0.01 mm is manufactured by turning process. A 50 μm thick…
- GATE 2019 ME Set 2 · Q27The most common limit gage used for inspecting the hole diameter is
Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.