GATE 2014 ME Set 2 · Question 32
Match the Machine Tools (Group A) with the probable Operations (Group B):
| Group A | Group B |
| :--- | :--- |
| P: Centre Lathe | 1: Slotting |
| Q: Milling | 2: Counter-boring |
| R: Grinding | 3: Knurling |
| S: Drilling | 4: Dressing |
- A
P-1, Q-2, R-4, S-3
- B
P-2, Q-1, R-4, S-3
- C
P-3, Q-1, R-4, S-2
- D
P-3, Q-4, R-2, S-1
GATE 2014 · Mechanical Engineering · Set 2 · IIT Kharagpur · printed as Q.22 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
Matching the machine tools in Group A with their associated operations in Group B:
- P. Centre Lathe 3. Knurling: Knurling is a cold-forming operation performed on a lathe using a hardened tool to produce a textured diamond or straight pattern on a cylindrical workpiece.
- Q. Milling 1. Slotting: Slotting or slot milling is a standard machining operation carried out on milling machines to produce keyways or slots.
- R. Grinding 4. Dressing: Dressing is the process of conditioning the working face of a grinding wheel to restore its sharpness and trueness.
- S. Drilling 2. Counter-boring: Counter-boring is performed on a drilling machine to enlarge the cylindrical entrance of an existing hole to accommodate bolt heads.
Hence, the correct matching is P-3, Q-1, R-4, S-2.
Answer: (C) P-3, Q-1, R-4, S-2
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2014 ME Set 2 · Q64A hole of 20 mm diameter is to be drilled in a steel block of 40 mm thickness. The drilling is performed at…
- GATE 2014 ME Set 4 · Q31Two separate slab milling operations, 1 and 2, are performed with identical milling cutters. The depth of…
- GATE 2014 ME Set 4 · Q64A cast iron block of 200 mm length is being shaped in a shaping machine with a depth of cut of 4 mm, feed of…
- GATE 2013 ME · Q15A steel bar 200 mm in diameter is turned at a feed of 0.25 mm/rev with a depth of cut of 4 mm. The…
- GATE 2012 ME · Q28In a single pass drilling operation, a through hole of 15 mm diameter is to be drilled in a steel plate of…
- GATE 2024 ME · Q64A flat surface of a C60 steel having dimensions of 100 mm (length) × 200 mm (width) is produced by a HSS…
Question from the official GATE 2014 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.