GATE 2014 ME Set 4 · Question 31
Two separate slab milling operations, 1 and 2, are performed with identical milling cutters. The depth of cut in operation 2 is twice that in operation 1. The other cutting parameters are identical. The ratio of maximum uncut chip thicknesses in operations 1 and 2 is ______
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.21 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In slab (plain) milling, the maximum uncut chip thickness is given by:
where is the feed per tooth, is the depth of cut, and is the cutter diameter.
Since the cutters and other cutting parameters (feed , cutter diameter , speed) are identical in both operations, is directly proportional to the square root of the depth of cut:
Given that :
Answer: 0.71 (acceptable range: 0.7 to 0.72)
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2014 ME Set 4 · Q64A cast iron block of 200 mm length is being shaped in a shaping machine with a depth of cut of 4 mm, feed of…
- GATE 2013 ME · Q15A steel bar 200 mm in diameter is turned at a feed of 0.25 mm/rev with a depth of cut of 4 mm. The…
- GATE 2012 ME · Q28In a single pass drilling operation, a through hole of 15 mm diameter is to be drilled in a steel plate of…
- GATE 2024 ME · Q64A flat surface of a C60 steel having dimensions of 100 mm (length) × 200 mm (width) is produced by a HSS…
- GATE 2022 ME Set 2 · Q54A straight-teeth horizontal slab milling cutter is shown in the figure. It has 4 teeth and diameter (D) of…
- GATE 2021 ME Set 1 · Q17In a machining operation, if a cutting tool traces the workpiece such that the directrix is perpendicular to…
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.