GATE 2013 ME · Question 15
1 markMultiple choiceManufacturing EngineeringBasic Machine Tools and Operations
A steel bar in diameter is turned at a feed of with a depth of cut of . The rotational speed of the workpiece is . The material removal rate in is
- A
160
- B
167.6
- C
1600
- D
1675.5
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
(D)
From the official answer key published by IIT Bombay.
Worked solution
The material removal rate (\text{MRR}) in orthogonal turning is given by:
where:
- Feed,
- Depth of cut,
- Cutting velocity,
Given and , the velocity in is:
Substituting the values into the MRR equation:
Answer: (D) 1675.5
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2012 ME · Q28In a single pass drilling operation, a through hole of 15 mm diameter is to be drilled in a steel plate of…
- GATE 2024 ME · Q64A flat surface of a C60 steel having dimensions of 100 mm (length) × 200 mm (width) is produced by a HSS…
- GATE 2022 ME Set 2 · Q54A straight-teeth horizontal slab milling cutter is shown in the figure. It has 4 teeth and diameter (D) of…
- GATE 2021 ME Set 1 · Q17In a machining operation, if a cutting tool traces the workpiece such that the directrix is perpendicular to…
- GATE 2021 ME Set 1 · Q18The correct sequence of machining operations to be performed to finish a large diameter through hole is
- GATE 2020 ME Set 1 · Q52A slot of 25 mm × 25 mm is to be milled in a workpiece of 300 mm length using a side and face milling cutter…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.