GATE 2014 ME Set 4 · Question 35
In a rolling process, the maximum possible draft, defined as the difference between the initial and the final thickness of the metal sheet, mainly depends on which pair of the following parameters?
P: Strain
Q: Strength of the work material
R: Roll diameter
S: Roll velocity
T: Coefficient of friction between roll and work
- A
Q, S
- B
R, T
- C
S, T
- D
P, R
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.25 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In a flat rolling operation, the condition for the workpiece to be drawn into the rolls without external assistance (self-feeding) is that the friction angle exceeds or equals the bite angle, .
From the geometry of rolling, the draft is for small angles. At the limiting condition , the maximum possible draft is:
where:
- is the roll radius ( is the roll diameter, Parameter R),
- is the coefficient of friction between the roll and the workpiece (Parameter T).
Hence, the maximum draft primarily depends on the roll diameter (R) and the coefficient of friction (T).
Answer: (B) R, T
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2013 ME · Q10In a rolling process, the state of stress of the material undergoing deformation is
- GATE 2012 ME · Q16A solid cylinder of diameter 100 mm and height 50 mm is forged between two frictionless flat dies to a…
- GATE 2012 ME · Q38In a single pass rolling process using 410 mm diameter steel rollers, a strip of width 140 mm and thickness…
- GATE 2025 ME · Q41A plate of 30 mm thickness is fed through a rolling mill with two powered rolls. Each roll has a diameter of…
- GATE 2022 ME Set 1 · Q56A 4 mm thick aluminum sheet of width w = 100 mm is rolled in a two-roll mill of roll diameter 200 mm each.…
- GATE 2021 ME Set 1 · Q50A 200 mm wide plate having a thickness of 20 mm is fed through a rolling mill with two rolls. The radius of…
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.