GATE 2014 ME Set 4 · Question 62
A GO-No GO plug gauge is to be designed for measuring a hole of nominal diameter with a hole tolerance of . Considering of work tolerance to be the gauge tolerance and no wear condition, the dimension (in ) of the GO plug gauge as per the unilateral tolerance system is
- A
- B
- C
- D
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.52 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
For the hole of nominal dimension with tolerance :
- Basic size
- Lower limit of hole (MMC)
- Upper limit of hole (LMC)
- Work tolerance
Gauge tolerance is of the work tolerance:
A GO plug gauge checks the Maximum Material Condition (MMC) of the hole, which corresponds to the minimum hole size (). According to the unilateral tolerance system for gauges, the gauge tolerance is placed inside the work tolerance zone (i.e., on the positive side for a GO plug gauge). With no wear allowance:
Answer: (D)
Practise Limits, Fits, Tolerances and Gauge Design
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Limits, Fits, Tolerances and Gauge Design
- GATE 2013 ME · Q37Cylindrical pins of 25+0.020 mm diameter are electroplated in a shop. Thickness of the plating is 30 2.0…
- GATE 2012 ME · Q3In an interchangeable assembly, shafts of size 25.000-0.010+0.040 mm mate with holes of size…
- GATE 2025 ME · Q25When assembled, the hole 30+0.030+0.000 mm and shaft 30+0.020-0.020 mm will result in
- GATE 2022 ME Set 1 · Q20The type of fit between a mating shaft of diameter 25.0-0.010+0.010 mm and a hole of diameter…
- GATE 2022 ME Set 2 · Q20A shaft of diameter 25-0.07-0.04 mm is assembled in a hole of diameter 25-0.00+0.02 mm. Match the allowance…
- GATE 2021 ME Set 2 · Q19The allowance provided in between a hole and a shaft is calculated from the difference between
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.