GATE 2015 ME Set 3 · Question 16
In a machining operation, if the generatrix and directrix both are straight lines, the surface obtained is
- A
cylindrical
- B
helical
- C
plane
- D
surface of revolution
GATE 2015 · Mechanical Engineering · Set 3 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
In machining operations, any engineered surface is generated by moving a generating line (called the generatrix) along a guide line (called the directrix):
1. Plane surface: When both the generatrix and directrix are straight lines moving relative to each other (e.g., in shaping, planing, or face milling), the resulting envelope forms a flat or plane surface.
2. Cylindrical surface: Generated when a straight generatrix moves along a circular directrix (e.g., cylindrical turning).
3. Helical surface: Generated when the directrix is a helix (e.g., thread cutting).
4. Surface of revolution: Produced when a generatrix rotates about a fixed axis.
Since both the generatrix and directrix are straight lines, a plane surface is obtained.
Answer: (C) plane
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2015 ME Set 3 · Q59A shaft of length 90 mm has a tapered portion of length 55 mm. The diameter of the taper is 80 mm at one end…
- GATE 2014 ME Set 2 · Q32Match the Machine Tools (Group A) with the probable Operations (Group B): | Group A | Group B | | :--- |…
- GATE 2014 ME Set 2 · Q64A hole of 20 mm diameter is to be drilled in a steel block of 40 mm thickness. The drilling is performed at…
- GATE 2014 ME Set 4 · Q31Two separate slab milling operations, 1 and 2, are performed with identical milling cutters. The depth of…
- GATE 2014 ME Set 4 · Q64A cast iron block of 200 mm length is being shaped in a shaping machine with a depth of cut of 4 mm, feed of…
- GATE 2013 ME · Q15A steel bar 200 mm in diameter is turned at a feed of 0.25 mm/rev with a depth of cut of 4 mm. The…
Question from the official GATE 2015 ME paper (Set 3), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.