GATE 2015 ME Set 3 · Question 59
A shaft of length has a tapered portion of length . The diameter of the taper is at one end and at the other. If the taper is made by tailstock set over method, the taper angle and the set over respectively are
- A
and
- B
and
- C
and
- D
and
GATE 2015 · Mechanical Engineering · Set 3 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
Given:
- Total shaft length,
- Taper length,
- Major diameter,
- Minor diameter,
The half taper angle satisfies:
The full taper angle is:
The tailstock set over is given by:
Hence, the taper angle is and the set over is , which corresponds to option (A).
Answer: (A)
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2014 ME Set 2 · Q32Match the Machine Tools (Group A) with the probable Operations (Group B): | Group A | Group B | | :--- |…
- GATE 2014 ME Set 2 · Q64A hole of 20 mm diameter is to be drilled in a steel block of 40 mm thickness. The drilling is performed at…
- GATE 2014 ME Set 4 · Q31Two separate slab milling operations, 1 and 2, are performed with identical milling cutters. The depth of…
- GATE 2014 ME Set 4 · Q64A cast iron block of 200 mm length is being shaped in a shaping machine with a depth of cut of 4 mm, feed of…
- GATE 2013 ME · Q15A steel bar 200 mm in diameter is turned at a feed of 0.25 mm/rev with a depth of cut of 4 mm. The…
- GATE 2012 ME · Q28In a single pass drilling operation, a through hole of 15 mm diameter is to be drilled in a steel plate of…
Question from the official GATE 2015 ME paper (Set 3), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.