GATE 2016 ME Set 2 · Question 48
In a structural member under fatigue loading, the minimum and maximum stresses developed at the critical point are and , respectively. The endurance, yield, and the ultimate strengths of the material are , and , respectively. The factor of safety using modified Goodman criterion is
- A
- B
- C
- D
GATE 2016 · Mechanical Engineering · Set 2 · IISc Bangalore · printed as Q.38 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
Given the stress limits under cyclic loading:
The mean stress and stress amplitude are:
Given material properties:
- Endurance limit:
- Yield strength:
- Ultimate tensile strength:
According to the Goodman fatigue failure criterion:
Checking for static yielding using the Langer line:
Since both criteria yield , the design is governed by .
Answer: (D)
Practise Design for Dynamic Loading & Fatigue
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Dynamic Loading & Fatigue
- GATE 2015 ME Set 1 · Q29Which one of the following is the most conservative fatigue failure criterion?
- GATE 2015 ME Set 3 · Q11For the given fluctuating fatigue load, the values of stress amplitude and stress ratio are respectively
- GATE 2014 ME Set 2 · Q20In a structure subjected to fatigue loading, the minimum and maximum stresses developed in a cycle are 200…
- GATE 2014 ME Set 3 · Q16A rotating steel shaft is supported at the ends. It is subjected to a point load at the center. The maximum…
- GATE 2013 ME · Q40A bar is subjected to fluctuating tensile load from 20 kN to 100 kN. The material has yield strength of 240…
- GATE 2025 ME · Q43The endurance limit of a specific grade of steel is same as its yield strength. The ultimate strength of…
Question from the official GATE 2016 ME paper (Set 2), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.