GATE 2020 ME Set 2 · Question 31
A machine member is subjected to fluctuating stress . The endurance limit of the material is 350 MPa. If the factor of safety used in the design is 3.5 then the maximum allowable value of is _________ MPa *(round off to 2 decimal places)*.
GATE 2020 · Mechanical Engineering · Set 2 · IIT Delhi · printed as Q.21 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
The given stress cycle is purely alternating (completely reversed):
The mean stress and stress amplitude are:
Since the mean stress is zero, all standard fatigue failure criteria (Soderberg, Goodman, Gerber) reduce to:
where:
- is the endurance limit,
- is the factor of safety.
Substituting the given values:
Answer: 100
Practise Design for Dynamic Loading & Fatigue
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Dynamic Loading & Fatigue
- GATE 2019 ME Set 1 · Q32During a high cycle fatigue test, a metallic specimen is subjected to cyclic loading with a mean stress of…
- GATE 2019 ME Set 2 · Q18Endurance limit of a beam subjected to pure bending decreases with
- GATE 2018 ME Set 2 · Q31Fatigue life of a material for a fully reversed loading condition is estimated from σa = 1100 N-0.15, where…
- GATE 2018 ME Set 2 · Q48A bar is subjected to a combination of a steady load of 60 kN and a load fluctuating between -10 kN and 90…
- GATE 2017 ME Set 1 · Q43A machine element has an ultimate strength (σu) of 600 N/mm2, and endurance limit (σen) of 250 N/mm2. The…
- GATE 2017 ME Set 2 · Q11A machine component made of a ductile material is subjected to a variable loading with σ = -50 MPa and σ =…
Question from the official GATE 2020 ME paper (Set 2), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.