GATE 2017 ME Set 2 · Question 11
A machine component made of a ductile material is subjected to a variable loading with and . If the corrected endurance limit and the yield strength for the material are and , respectively, the factor of safety is ______
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
For a component under cyclic loading, the mean stress and stress amplitude are defined as:
Given and :
Since the mean stress is zero, the loading is completely reversed. Under completely reversed loading, standard fatigue failure criteria (Soderberg, Goodman, or Gerber) all reduce to:
where is the corrected endurance limit and is the factor of safety.
Substitute and :
Answer: 2
Practise Design for Dynamic Loading & Fatigue
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Dynamic Loading & Fatigue
- GATE 2016 ME Set 2 · Q48In a structural member under fatigue loading, the minimum and maximum stresses developed at the critical…
- GATE 2015 ME Set 1 · Q29Which one of the following is the most conservative fatigue failure criterion?
- GATE 2015 ME Set 3 · Q11For the given fluctuating fatigue load, the values of stress amplitude and stress ratio are respectively
- GATE 2014 ME Set 2 · Q20In a structure subjected to fatigue loading, the minimum and maximum stresses developed in a cycle are 200…
- GATE 2014 ME Set 3 · Q16A rotating steel shaft is supported at the ends. It is subjected to a point load at the center. The maximum…
- GATE 2013 ME · Q40A bar is subjected to fluctuating tensile load from 20 kN to 100 kN. The material has yield strength of 240…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.