GATE 2020 ME Set 2 · Question 32
A bolt head has to be made at the end of a rod of diameter by localized forging (upsetting) operation. The length of the unsupported portion of the rod is 40 mm. To avoid buckling of the rod, a closed forging operation has to be performed with a maximum die diameter of _________ mm.
GATE 2020 · Mechanical Engineering · Set 2 · IIT Delhi · printed as Q.22 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
In upset forging, the rules governing stability and prevention of buckling are:
1. Rule 1: The maximum length of unsupported stock that can be upset in one blow without buckling is three times the rod diameter:
Here, the unsupported length is , so open upsetting would cause buckling.
2. Rule 2: Lengths of stock greater than can be upset successfully in a closed die cavity in one blow, provided the diameter of the die cavity (upset diameter ) does not exceed times the rod diameter:
Therefore, to avoid buckling of the rod, the maximum die diameter is .
Answer: 18
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2019 ME Set 2 · Q62The thickness of a sheet is reduced by rolling (without any change in width) using 600 mm diameter rolls.…
- GATE 2017 ME Set 2 · Q52A strip of 120 mm width and 8 mm thickness is rolled between two 300 mm-diameter rolls to get a strip of 120…
- GATE 2016 ME Set 1 · Q62A 300 mm thick slab is being cold rolled using roll of 600 mm diameter. If the coefficient of friction is…
- GATE 2015 ME Set 1 · Q31Match the following products with preferred manufacturing processes: | Product | Process | | :--- | :--- | |…
- GATE 2015 ME Set 1 · Q47In a slab rolling operation, the maximum thickness reduction (Δ hmax) is given by Δ hmax = μ2 R, where R is…
- GATE 2015 ME Set 3 · Q41In a rolling operation using rolls of diameter 500 mm, if a 25 mm thick plate cannot be reduced to less than…
Question from the official GATE 2020 ME paper (Set 2), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.