GATE 2018 ME Set 2 · Question 31
Fatigue life of a material for a fully reversed loading condition is estimated from
where is the stress amplitude in MPa and is the failure life in cycles. The maximum allowable stress amplitude (in MPa) for a life of cycles under the same loading condition is ________ (correct to two decimal places).
GATE 2018 · Mechanical Engineering · Set 2 · IIT Guwahati · printed as Q.21 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
The fatigue life relationship for the material under fully reversed loading is given by:
where is the stress amplitude in MPa and is the number of cycles to failure.
For a design life of cycles, substituting into the equation gives:
Since :
Thus, the maximum allowable stress amplitude is .
Answer: 195.61
Practise Design for Dynamic Loading & Fatigue
19 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Dynamic Loading & Fatigue
- GATE 2018 ME Set 2 · Q48A bar is subjected to a combination of a steady load of 60 kN and a load fluctuating between -10 kN and 90…
- GATE 2017 ME Set 1 · Q43A machine element has an ultimate strength (σu) of 600 N/mm2, and endurance limit (σen) of 250 N/mm2. The…
- GATE 2017 ME Set 2 · Q11A machine component made of a ductile material is subjected to a variable loading with σ = -50 MPa and σ =…
- GATE 2016 ME Set 2 · Q48In a structural member under fatigue loading, the minimum and maximum stresses developed at the critical…
- GATE 2015 ME Set 1 · Q29Which one of the following is the most conservative fatigue failure criterion?
- GATE 2015 ME Set 3 · Q11For the given fluctuating fatigue load, the values of stress amplitude and stress ratio are respectively
Question from the official GATE 2018 ME paper (Set 2), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.